Error Codes - Intec 980951 Manual

• Damaged battery: The «
and the charger enters stand-by mode. The display shows the message "Errx", where 'x' is
the number corresponding to the cause of the error (see table below). Single two second
audible warning.
• Polarity reversal: The «
"Err7" with a two second audible warning.

4. ERROR CODES

Display Possible cause
indication
Leads disconnected, leads short-
circuited.
Er01
Battery completely short-circuited.
Battery faulty or unrecoverable. No
Er02 current accepted after 20 hours of
recovery.
Internal
Er03
charger. Battery charger overload.
Voltage error.
Battery voltage too low. (You are
attempting to charge a 6 V battery).
Er04
One or more elements of the battery
has/have short-circuited.
Battery voltage too high compared
Er05 to that set. (You are attempting to
charge a 24 V battery).
Battery capacity excessive. Unable
Er06
to reach end condition.
The clamps of the output leads
Er07 and LED
are not connected correctly to the
« Reverse »
battery.
Excessively high output current.
Er08
Current exceeds maximum limit.
5. OPERATING BATTERY CHARGER
1. Before starting to charge the battery, make sure that the power supply lead is not
plugged into the mains supply!
Charging batteries connected to motor vehicle
2. Locate the motor vehicle's earthing point, which is normally connected to the negative
battery terminal.
EN
Fault » LED turns on and the «
Reverse » LED switches on, and the display shows the message
overheating of battery
- 13 -
Start/Stop » LED switches off,
Solution
Position the clamps correctly and
start charging the battery again.
Contact a battery service center.
The battery may be defective.
Remove any objects that could be
covering the ventilation area of the
battery charger or move it to a cooler
area. Wait for the battery charger to
start again automatically.
Set a « Recovery » cycle. Only use the
battery charger with supported 12 V
batteries.
Start charging the battery again.
The battery may be defective.
Only use the battery charger with
supported 12 V batteries. Start
charging the battery again.
Use a battery charger with greater
capacity.
Position the clamps correctly and
start charging the battery again.
Reduce battery absorption.