General Information - Intec 980951 Manual

1.14 Never put the appliance on top of the battery while using it.
1.15 Do not attempt to charge a damaged battery.
1.16 Never charge a frozen battery.
1.17 Keep away from jewelry. Remove personal metal objects such as rings, bracelets, necklaces
and watches when working with a lead-acid battery. A lead-acid battery can produce a
short-circuit current high enough to weld a ring or the like to metal, causing a severe burn.
1.18 Keep away from tools. Be extra cautious, to reduce the risk of dropping a metal tool onto
the battery. It might spark or short-circuit the battery or other electrical part that may
cause an explosion.
1.19 Never allow clamps to touch together or contact the same piece of metal.
1.20 Determine the voltage of the battery by referring to the vehicle owner's manual and make
sure that the output voltage of the appliance is correct.
1.21 The battery terminal not connected to the chassis has to be connected first. The other
connection is to be made to the chassis, remote from the battery and fuel line. The battery
charger is then to be connected to the supply mains.
1.22 After charging, disconnect the battery charger from the supply mains. Then remove the
chassis connection and then the battery connection.
1.23 Refer to the instructions for cleaning and user maintenance.
1.24 Unplug the appliance from the supply mains before attempting any maintenance or
cleaning.

2. GENERAL INFORMATION

2.1 Signaling LEDs
On the front panel of the battery charger there are 5 buttons and 15 LEDs.
2.2 Digital display
The « A/V » selection button allows you to view the voltage or current on the display.
3. BATTERY CHARGER FUNCTIONS AND OPERATING MODES
« Full » LED: Battery is charged and is in charge maintenance status.
« Charging » LED: Battery is charging.
« Fault » LED: Battery is damaged.
« Reverse » LED: Polarity reversal.
« ON » LED: The battery charger is on (blue).
« Start/Stop » button: Starts or stops supply in selected mode.
1 Operating status LED (yellow) indicates if it is working in the selected
mode.
« Volt/Batt. » button: Selects supply voltage or type of battery to charge.
3 Supply voltage and battery type LEDs (yellow).
« Amperage » button: Selects supplied current.
4 Supplied current LEDs (yellow).
« Function » button: Selects operating mode.
2 Operating mode LEDs (yellow): «
« A/V » button (display): Selects information to display.
Flash » or «
- 10 -
Charge ».
EN