Intec 980951 Manual page 14

3. Charge a battery with negative earth, grounded to the motor vehicle's chassis, as
follows:
• Connect the output lead with the red clamp to the positive terminal (+) of the battery.
• Connect the output lead with the black clamp to the motor vehicle's earthing point,
keeping it away from the battery and fuel pipe.
Charge a battery with positive earth, grounded to the motor vehicle's chassis, as follows:
• Connect the output lead with the black clamp to the negative terminal (-) of the battery.
• Connect the output lead with the red clamp to the motor vehicle's earthing point, keeping
it away from the battery and fuel pipe.
Connecting batteries that are not connected to a motor vehicle
2. Connect the output lead with the red clamp to the positive terminal (+) of the battery.
3. Connect the output lead with the black clamp to the negative terminal (-) of the
battery.
ATTENTION: Make sure that both clamps of the output leads generate a suitable contact with
their corresponding terminals.
4. Once the output leads have been connected to the battery, plug the power supply lead
of the battery charger into the mains socket, making sure that the voltage matches the
rated voltage of the battery charger; having done this, the battery charger will emit an
acoustic signal for 0.5 seconds, and all the LED indicators on the control panel will switch
on for 2 seconds; at this stage, the display shows
5. The battery charger is configured in stand-by mode: for example «
LED on, « Charge
saved.
6. At this stage, with the battery charger in stand-by mode, set the charging parameters
suitable for the type of battery to be charged, using the buttons on the control panel. The
charging parameters selected are displayed by the corresponding LED, which switches on.
Settable charging parameters:
• « Function » Depending on the work cycle, select: «
button
• « Amperage » -
button during reprogramming operations. OR
-
feature.
• « Volt / Batt. »
-
button voltage during reprogramming operations (ONLY «
select three different supply voltages. OR
-
mode), select: «
7. Once the charging parameters have been set, press the «
charging the battery. When the «
is charging; the display will show the charging current and the voltage of the battery.
8. The «
Charging
9. When the «
will switch to the maintenance phase, keeping the state of efficiency of the battery
constantly monitored, so that it is always at an optimal level of charge. In this charging
phase, the appliance can be left connected to the battery for several months.
10. If you wish to end or interrupt the charging cycle, follow the charge end/interruption
» 5-50 Ah LED on. The LEDs light up differently based on the last program
Based on the supply current required to support the battery voltage
Based on the capacity of the battery to charge, select the «
Depending on the supply voltage required to support the battery
Depending on the construction/type of the battery (ONLY «
Wet
Start/Stop
» LED remains lit in phases "I" and "U0" whilst the battery is charging.
Full » LED switches on, the battery is fully charged (100 %), and the charger
"- - -
Flash
», « LiFePO4 » or « AGM
» and « Charging
- 14 -
-".
ON » LED on, «
», « Charge » or «
Flash » mode), you can
».
Start/Stop » button to start
» LEDs light up, the battery
Wet »
Recovery ».
Charge »
Charge »
EN