Installation - Electrolux ENN2814COW User Manual

16 www.electrolux.com
Problem
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
7.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your After Sales
Service.

8. INSTALLATION

8.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
Possible cause
The appliance is in dem-
onstration mode.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
The FastFreeze function is
switched on.
The ShoppingMode func-
tion is switched on.
There is no cold air circu-
lation in the appliance.
7.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective
class indicated on the rating plate of the
appliance:
Solution
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Refer to "FastFreeze func-
tion".
Refer to "ShoppingMode
function".
Make sure that there is cold
air circulation in the appli-
ance.
"Installation".
door gaskets. Contact the After Sales
Service.