Installation; Location; Door Reversal - Electrolux EU 0562 C Installation And Instruction Manual

INSTALLATION
IMPORTANT
If you are discarding an old refrigerator or freezer
that has a lock on the door, you MUST ensure that
the lock is made unusable to avoid young children
being trapped inside.
LOCATION
Place the appliance away from all heat sources,
such as, radiators, cookers, direct sunlight etc.
Best results are obtained with room temperatures
ranging between +16°C and +32°C.
You should ensure that air can circulate freely
around the back, top and bottom of the appliance.
There must be a minimum distance of 100mm (4")
between the top of the appliance and any
overhanging kitchen furniture, see fig 1(A).
However the recommended installation would be as
shown in Fig 1(B), with no overhanging kitchen
furniture.
Fig 1
DOOR REVERSAL
Before carrying out this procedure, disconnect the
appliance from the electricity supply.
Remove the hinge cap and 2 screws securing the
top hinge. Remove the 2 white caps on the
opposite side of the cabinet, and refit the hinge
in the vacant holes. Replace the 2 white caps
in the holes that have been vacated by the
hinge. (See fig 2)
Remove the 2 screws securing the bottom
hinge and refit on the opposite side. (See fig 3).
Remove the 2 screws securing the door handle
and refit on the opposite side of the door (the
holes are already provided). Replace caps in
vacant holes.
Please ensure that when the appliance is
installed it is easily accessible for the engineer
in the event of a breakdown.
A/E/1-1 (97.)
5