Electrolux ENN2814COW User Manual page 15

Problem
The compressor does not
start immediately after
pressing the FastFreeze, or
after changing the tempera-
ture.
The compressor does not
start immediately after
pressing the Shopping-
Mode, or after changing the
temperature.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set. The FastFreeze or Shop-
Possible cause
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The FastFreeze function is
switched on.
The ShoppingMode func-
tion is switched on.
The water drainage plug
is not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
This is normal, no error
has occurred.
This is normal, no error
has occurred.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
pingMode function is
switched on.
ENGLISH
Solution
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastFreeze func-
tion".
Refer to "ShoppingMode
function".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" chapter.
The compressor starts after a
period of time.
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "FastFreeze
or ShoppingMode function".
15