Table of Contents
Advertisement
- Misalignment may occur with two-sided printing.
The following may occur with Tray 1.
- Paper jams may occur when using paper sizes A5, B6 or smaller.
- Paper may remain inside the machine after printing.
- Paper jams may occur when using paper sizes smaller than A5 for two-sided printing.
The following may occur with Tray 2 (250-Sheet Feeder) (optional).
- Paper jams may occur when using paper size A5 or smaller.
- Paper may remain inside the machine after printing.
The following may occur with the Bypass Tray.
- Paper jams may occur when using paper size A5 or smaller for two-sided printing.
[Banner Sheet]
Specify banner sheet insertion position and the tray from which to print.
[Report 2-Sided Print]
Specify whether to print reports on both sides of a sheet of paper.
[Letterhead 2-Sided Print]
Specify whether to print on both sides of letterhead.
[Hex Dump]
All data sent to the machine is printed in hexadecimal and representation, facilitating
troubleshooting analysis. Control codes are not executed.
[Low Toner Alert Message]
Specify whether to show the alert message when toner is low.
[End of Drum Life]
Specify whether to stop printing when a drum cartridge reaches the end of its service life.
Note
Make sure that this menu should be specified before the message is displayed to notify you to replace the
drum cartridge. This setting cannot be changed after the message of the drum cartridge replacement is
displayed.
[Cancel Printing]
Stops printing when a drum cartridge reaches the end of its life.
[Continue Printing]
Does not stop printing even when a drum cartridge reaches the end of its life.
Note
Since print quality is not guaranteed, replacing the drum cartridge with a new one is recommended when
the following message appears: "[Order Drum Cartridge]."
When the following message appears, printing will not be possible until the drum cartridge is replaced:
"[Replace Drum Cartridge]."
68
6 Changing the Machine Settings
Advertisement
Table of Contents
Troubleshooting
