Setting The Clock; Playing A Disc - Sony ICF-CD833 Operating Instructions Manual

Cd clock radio
Hide thumbs Also See for ICF-CD833:
Table of Contents

Advertisement

Setting the Clock
Set the time when the CD or radio is turned off.
1. Plug in the unit.
The display will flash "AM 12:00".
2. While holding down TRACK/ENTER/
CLOCK, press either TUNING/TIME
SET + or — till the correct time appears
in the display.
When you release TRACK/ENTER/
CLOCK, the clock begins to operate and
"an
: " flashes.
> To set the current time rapidly, keep pressing
the + or - button while holding down TRACK/
ENTER/CLOCK.
e To set the current time from zero second, at
step 2, release TRACK/ENTER/CLOCK with the
time signal.
Playing a Disc
An 8 cm (3-inch) CD can be played without an
adaptor.
1, Slide PULL OPEN out to open the CD
compartment lid and place a disc.
bb]
Slide.
Label surface up.
Se
OLL
ka
Close the lid.
2. Press CD Pil and the display lig
"01". And the current number (
99) appears in the display wind
After 10 seconds, the indication
becomes current time, but the "(
indication remains.
CD pe
w
G-
U:
€ of
3. Adjust VOLUME.
Locating a Particular Portion
Locating a particular selection (AMS*)
To locate the beginning of the current sel
press kéd
once.
To locate the next selection, press PPh o:
Locating a particular point in a selectic
(SEARCH)
To go back at high speed, keep aa
pres
To go ahead at high speed, keep 1
pre
* AMS is the abbreviation of Automatic N
Sensor.
e If you press taa repeatedly, the player
the previous selections. If you press PP
repeatedly, the player locates the next
selections and stops at the last selection.
e To stop play, press OFF/ALARM RESET.
s To pause, press CD PAI and the "CD b>
indication flashes. To resume play, pres:
CD Pil again.
e To change the clock mode to track mode
TRACK/ENTER/CLOCK.
Press TRACK/ENTER/CLOCK again, and
current time appears.
e To obtain a powerful bass, set MEGA BA
ON.
x To eject a disc, slide PULL OPEN out.
e To handle compact discs
This way
Handle the dis
by its edge.
Not this way
Do not touch tk
surface.
Do not stick pat
tape nor write
anything on the
surface.

Advertisement

Table of Contents
loading

Table of Contents