Table of Contents
Advertisement
166
MAINTENANCE
it is very important to con-
sult a specialist workshop
beforehand, preferably an
authorised BMW Motorrad
retailer. In these cases, the data
programmed into the control
units has to be changed to suit
the new wheel sizes.
Removing front wheel
The front-wheel cover
must be loosened on one
side to facilitate removal and
installation of the front wheel.
Place the motorcycle on an
auxiliary stand.
Install the rear-wheel stand.
(
156)
Raise front of motorcycle un-
til the front wheel can turn
freely.
Install the front-wheel stand.
(
156)
Remove screws 1.
Disengage the sensor cable
from holders 2.
Remove screw 1 and remove
wheel speed sensor 3 from
its bore.
Remove screws 1 on the left
side.
Disengage holder 2 for the
sensor cable and brake cal-
iper 3.
Advertisement
Chapters
Table of Contents
