Page 3
- Consumption Power : 12Watt, Max Storage Temperature : 0 ~75℃ 4. Switch Input mode - Possible to select CAR model while switching mode by DIP S/W - By button on the Commander in the car via CAN 5. Not support OSD menu GU Electronic...
* UART Voltage Level *Touch Connect - TXD, RXD = 3.3V Level * Output current ① ② ③ ④ - ACC POWER = +12V, Max 200mA ① Y- - REAR POWR = +12V, Max 200mA ② X- ③ Y+ ④ X+ GU Electronic...
OFF : Used ON : Not Used HDMI(DEX) OFF : Used (Audio not support) ON : OEM REAR TYPE OFF : External CAR type SEL Right Picture Navi Model SEL Down Picture CAR type SEL Right Picture AVM(SVM)-HDMI SAMSUNG-DEX M2C/FINE/KPLAY-2 GU Electronic...
Page 14
9. Install Manual 3. Installation HDMI Connection (Audio not support) AUDIO-UNIT Mode Change LVDS-IN Cable LVDS-OUT Cable DIP-SW M-CAN-H M-CAN-L I-CAN-L I-CAN-H I-CAN not use GU Electronic...
Page 15
2. LVDS cable must be connected correctly according to the manual 3. Insulate the end of wire by using electrical tape 4. The installation should be done by expert 5. GU electronic does not take any responsibility for any problem caused by wrong installation GU Electronic...
Need help?
Do you have a question about the HW-REV10 and is the answer not in the manual?
Questions and answers