Operating The Unit; Changing The Battery; Setting Examples - Boss Fuzz FZ-3 Owner's Manual

OPERATING THE UNIT
When you have made the necessary 2
connections, set the knobs as shown in
the illustration.
* Cİ =
LEVEL FUZZ
CHANGING THE BATTERY
When the indicator goes dim or no longer
lights while an effect is on, it means that the
battery is nearly dead and must be re-
placed.
Replace the battery following the steps
below. Thumbscrew
Pedal
Spring Base
Coil Spring
ZĘ
y Guide
LS Bush
Hole
+
Battery Snap
Battery
Housing
SV Ballery
12
Depress the pedal switch to turn the
effect on. (Make sure the CHECK indica-
tor lights.)
Adjust the depth of the Fuzz effect
using the FUZZ knob.
1 Loosen the thumbscrew at the front of the
pedal, then lift the pedal upwards to open
the unit.
* The thumbscrew can be left in the pedal
while changing the battery.
ro
Remove the old battery from the battery
housing, and remove the snap cord con-
nected to it.
3 Connect the snap cord to the new battery,
and place the battery inside the battery
housing.
* Be sure to carefully observe the battery's
połarity (+ versus -).
4 _ Slip the coil spring onto the spring baseon
the back of the pedal, then close the
pedal.
* Carefully avoid getting the snap cord
caught in the coil spring.
Finally, insert the thumbscrew into the
guide bush hole and fasten it securely.
a
4 Adjust the tone using the TONE knob.
SETTING EXAMPLES
For Single-Coil Guitar
a=
CHECK
. 5 A |
© =~ © |
LEVEL O
FUZZ
|
|
5
Adjust the LEVEL knob so that the level
ofthe sound obtained when the effectis
on is equal to that obtained when it is
off.
11
For Humbacking Guitar
13