HOMCOM 820-052 Assembly & Instruction Manual page 8

(V) Set temperature
Then press the " TIMER SET" button, and the temperature set starts blinking. At this moment,
the temperature displayed is normally set temperature, which can be adjusted by pressing "+"
or "-"
(VI) Press " TIMER SET" button to continue setting, and press "OK" complete the setting
6. Timer switch
"TIMER ON/OFF" is to control the timed opening and closing
Restart the machine after power is cut off, the original setting is kept, but the current date and
time must be reset
Note 1: When the week timer is power on, you should turn on the heating function, or else
when the machine is working again, there will be only the flame effect working.
NOTE 2: Repeat the same procedures to set more timing cycles if required after the 01 timing
cycle is finished.
NOTE 3: When the week timer setting is finished, "TIMER ON/OFF" function can be effective.
Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the fire overheats (e.g. due to
blocked air vents). For safety reasons, the fire will NOT automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at least 15 minutes.
Reconnect to the mains supply and switch on the appliance.
Troubleshooting
Cleaning and Maintenance
Warning- Always disconnect from the mains supply before cleaning heater.
For general cleaning use a soft clean duster - never use harsh abrasive or cleaners.
The glass viewing screen should be cleaned carefully with a soft cloth. DO NOT use
proprietary glass cleaners.
This product does not use a standard bulb for its flame effect. The appliance uses an
electronically controlled LED system to create the effect, therefor no parts need to be replaced.
There are no user-serviceable parts on this appliance. Under no circumstances should the
appliance be serviced be anyone other than a qualified electrician.
Disposal
At the end of the product's serviceable life it should be disposed of thoughtfully and
safely in accordance with local authority regulations. The plug should be Removed from
the power supply cord and the power cord cut from the heater.
8