HOMCOM 820-052 Assembly & Instruction Manual page 7

When turned on, the fireplace can automatically change the heating mode depending on the
set temperature and the room temperature.
During a timed starting process, it is possible to start heating ahead of schedule.
3. Setting the day and time
1) Settings are done on the remote controller
2) Press "DATE TIME" button, then press the "▲" or "▼" key to select the day
3) Press "DATE TIME" button again, then press the "+" or "-" to set the hour
4)Press "DATE TIME" button again, then press the "+" or "-" to set the minute
5) Press "OK" button to complete
4. Temperature setting
The default set temperature is 20 ℃, press "+" or "-" on the remote controller to set the
temperature, which ranges from 15 to 30℃. And this setting is only for the temperature in the
normally mode, not for the temperature in the timer mode.
NOTE: The set temperature must be higher than the room temperature for the heat working.
5. Timer setting
1)Description of timer setting
There are up to 10 items for timer setting
Each setting item has its date, power-on time and shutdown time
The max. duration of each setting item is 23 hours 50 minutes
The setting date for each item can be any day or days of a week
The date in each setting item represents the date of power-on time
If the shutdown time of the setting falls on the second day, it is unnecessary to set the date –
you just set the shutdown time
2)Steps to view the timer setting
Press the "TIMER SET" button
Press the "+" or "-" to check the power-on time of the timer one by one.
For checking the shutdown time, press the "▲" button
Press the "+" or "-" to continue viewing
For deleting the current item of setting, press "C" to delete
3) Steps for timer setting
(I) Select the settings of the serial number
Press the "TIMER SET" button, and the serial number starts blinking
Press the "+" or "-" to change the serial number until you get the serial number that you need to
set or modify.
(II) Select date
Press " TIMER SET" button once again, and the cursor on the left side of day starts blinking
Press the "▲" or "▼" keys to move the cursor to the corresponding day, press the "+" to add
the corresponding day, or press "-" to delete the day until you have completed the selection of
all dates.
(III) Set the start time
Continue to press the " TIMER SET" button, the hour starts blinking
Press the "+" or "-" to adjust the hour
Continue to press the " TIMER SET" button, the minute starts blinking
Press the "+" or "-" to adjust minute
(IV) Set the shutdown time
Then press the "TIMER SET" button, the display is off, and the hour starts blinking
Press the "+" or "-" to adjust the hour.
Continue to press the " TIMER SET" button, the minute starts blinking
Press the "+" or "-" to adjust minute
7