Assembly Instructions - Project Source 999-LUT18WHT Manual

ASSEMBLY INSTRUCTIONS

SINK
1. Lay the sink basin (A) upside down on the floor
or a sturdy table top.
Note: The back "lip" should hang off of the flat
surface to prevent bending or breaking.
2. Insert 4 upper legs (B) into the corners of the sink
basin. Push the upper legs into the sink until tight,
or when you hear, or feel, a "click".
3. Insert 4 lower legs (C) into the bottom of the
upper legs. Push the lower legs into the upper
legs until tight, or when you hear, or feel a "click".
4. Screw 4 sink feet (D) onto the lower legs by hand
until tight. You will be able to unscrew each foot
as needed to level the sink on an uneven floor
once it is in its final position.
D
C
B
A
5