Table of Contents
Advertisement
1,2. Alignment tape
To be used for check and adjustment of interchangeability of
the mechanism.
(Video: Color bar signal, Audio: Non-signal)
3. Cassette torque meter
This is used to cheek the back tension and play torque during
mechanism adjustment.
4. Roller driver
To be used to turn the Roller driver to adjustment of the linear-
ity of playback envelope.
5.INF adjustment lens
To be used for adjustment of the camera system. For the us-
age of the INF adjustment lens, refer to the Service Bulletin
No. YA-SB-10035.
6.Conn. ring
The connector ring to attach the INF lens to the head of the OP
lens. For the usage of the Conn.ring.
7.Gray scale chart
To be used for adjustment of the camera system. For the us-
age of the INF adjustment lens, refer to the Service Bulletin
No. YA-SB-10035.
8.Color bar chart
To be used for adjustment of the camera system. For the us-
age of the INF adjustment lens, refer to the Service Bulletin
No. YA-SB-10035.
9.INF lens holder
To be used together with the Camera stand (11) for operating
the Videocamera in the stripped-down condition such as the
status without the exterior parts or for using commodities that
are not yet conformable to the interchangeable ring. For the
usage of the INF lens holder, refer to the Service Bulletin No.
YA-SB-10035.
10.Light box assembly
To be used for adjustment of the camera system. For the us-
age of the Light box assembly, refer to the Service Bulletin No.
YA-SB-10035.
11.Camera stand
To be used together with the INF adjustment lens holder. For
the usage of the Camera stand, refer to the Service Bulletin
No. YA-SB-10035.
12. Jig connector cable
To be connected to the Jig connector jack of the main board
and used for measurement and adjustment.
MAIN CN25
AL_L3.2V
1
MCU_RST
11
NC
2
V_TP_FM
12
DIAL_PB
3
V_FF
13
DIAL_MN
4
EJECT_SW
14
JIGCN_SW
5
PB_CTL
15
GND
6
GND
16
TXD
7
V_OUT
17
RXD
8
AO_SIG_J
18
PLI_AD
9
V_OVL
19
VPP_7.8V
10
DISCHG_L
20
13.Communication Cable
Connect the Communication cable between the PC cable and
Jig connector cable when performing a PC adjustment.
14.Service support system
To be used for adjustment with a personal computer. Software
can be downloaded also from JS-net.
15.PC cable
To be used to connect the Videocamera and a personal com-
puter with each other when a personal computer issued for ad-
justment.
16.Cleaning cloth
Recommended the Cleaning cloth to wipe down the video
heads, mechanism (tape transport system), optical lens sur-
face.
JIG BOARD (LABEL)
1
AL_L3.2V
2
NC
3
DIAL_PB
4
DIAL_MN
5
JIGCN_SW
6
GND
7
TXD
8
RXD
9
PLI_AD
10
VPP_7.8V
11
MCU_RST
12
V_TP_FM
13
V_FF
14
EJECT_SW
15
PB_CTL
16
GND
17
V_OUT
18
AO_SIG_J
19
V_OVL
20
DISCHG_L
Fig.3-2-2
(No.86712)1-19
Advertisement
Table of Contents
