JVC GR-SXM161 Instructions Manual

Compact vhs camcorder

Advertisement

INSTRUCTIONS
COMPACT VHS CAMCORDER
GR-SXM161
For Customer Use:
Enter below the Model No. and Serial No. which is
located on the bottom of the camcorder. Retain this
information for future reference.
Model No.
Serial No.
Dear Customer,
Thank you for purchasing the JVC Compact VHS camcorder. Before use, please read
"PRECAUTIONS" (
Automatic Demonstration takes place when "DEMO MODE" is set to "ON"
(factory-preset).
• Available when the Power Switch
located on the switch.
• Performing any operation during the demonstration stops the demonstration temporarily. If no operation
is performed for more than 1 minute after that, the demonstration will resume.
• "DEMO MODE" remains "ON" even if the camcorder power is turned off.
• To cancel Automatic Demonstration, set the Power Switch
while the demo is in progress. This takes you directly to the demo mode's Setting Menu (so you will not
have to go through the main Menu Screen). Rotate the MENU Wheel
NOTES:
• When a tape whose Erase Protection tab is in the position that allows recording is loaded in the
camcorder, demonstration is not available.
• If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration
activated on the LCD monitor or viewfinder.
pg. 3, 4) to ensure safe use of this product.

AUTOMATIC DEMONSTRATION

@
is set to "
ENGLISH
COPYRIGHT© 2003 VICTOR COMPANY OF JAPAN, LTD
" or "
" while pressing down the Lock Button
@
to "
" and press the MENU Wheel
1
Printed in Malaysia
US
1203YDR-NF-VM
1
to select "OFF" and press it.
LYT1249-001B
!
1
in

Advertisement

Table of Contents
loading

Summary of Contents for JVC GR-SXM161

  • Page 1: Automatic Demonstration

    Model No. Serial No. Dear Customer, Thank you for purchasing the JVC Compact VHS camcorder. Before use, please read “PRECAUTIONS” ( pg. 3, 4) to ensure safe use of this product. Automatic Demonstration takes place when “DEMO MODE” is set to “ON”...
  • Page 2: Provided Accessories

    (for Cassette Adapter) NOTE: In order to maintain optimum performance of the camcorder, provided cables may be equipped with one or more core filter. If a cable has only one core filter, the end that is closest to the filter should be...
  • Page 3: Safety Precautions

    However, live recording and LCD monitor/viewfinder playback are possible any- where. • Use the JVC BN-V10U/V12U/V20U/V400U battery packs and, to recharge them or to supply power to the camcorder from an AC outlet, use the provided multi-voltage AC Adapter.
  • Page 4: Important Safety Instructions

    Please call 1-800-8-BATTERY™ for information on Ni-Cd battery recycling and disposal bans/restrictions in your area. JVC’s involvement in this program is part of our commitment to preserving our environment and conserving our natural resources.
  • Page 5: Table Of Contents

    Brighten The LCD Monitor ... pg. 11, 22 Cassette Adapter ... pg. 16 Charging The Battery Pack ... pg. 6 Clean The Camcorder ... pg. 27 Connection To a VCR/TV ... pg. 15 Counter Memory ... pg. 14 Darken The Image ... pg. 18 Darken The LCD Monitor ...
  • Page 6: Ac Adapter

    To AC outlet CHARGING THE BATTERY PACK 1) Hook the end of the battery pack to the camcorder and push the battery in until it locks in place. • If the battery pack is attached in the wrong position, a malfunction may occur.
  • Page 7: Date/Time Settings

    TV, see DATE/TIME DISP. ( • The date/time cannot be stored in memory if the built-in clock battery runs out. Consult an authorized JVC dealer for replacement, or set the date/time as necessary before you start shooting. ” or “ ”.
  • Page 8: Diopter Adjustment

    Some cassettes have removable tabs. If the tab has been removed, cover the hole with adhesive tape. PAUSE • The cassette holder cannot be opened while the camcorder is in the record mode or detached from the power source. Cassette holder , then fold it . Then...
  • Page 9 – – – – – – – Refer to this diagram while reading the instructions. During shooting Keep the lens cap attached to the camcorder. Cassette holder 90° 90° 180° LCD monitor Microphone LCD Monitor/Viewfinder Indications – – – –...
  • Page 10: Instant Titles

    • MENU Wheel [–, +] ... • BRIGHT Wheel [–, +] ... • Speaker Volume Control [VOL.] ... • TRACKING Wheel [–, +] ... 5-Second Recording Button [5 SEC. REC] ... Power Zoom Lever [T/W] ... • Manual Focus Button [ FOCUS] ...
  • Page 11: Playback

    To resume normal playback, press 4/6 For VIDEO RECORDING/VIDEO PLAYBACK • The camcorder shuts off automatically after about 5 minutes in the Record-Standby or Stop mode. To turn on again, set the Power Switch “OFF”, then to “...
  • Page 12: Auto Focus

    5Sec. Rec is reserved. 3) Press the Recording Start/Stop Button Recording starts, and after 5-second recording is finished, the camcorder re-enters the Record– Standby mode automatically. 4) To cancel the 5Sec. Rec. function, press 5SEC. again so that •...
  • Page 13: Quick Review

    • Do not use near flammable or explosive materials. • It is recommended that you consult your nearest JVC dealer for replacing the video light. Zooming To produce the zoom in/out effect. Digital circuitry extends the maximum magnification offered by optical zoom.
  • Page 14: Counter Memory

    “OFF” and then “PLAY” again. “AT” blinks. When Auto Tracking finishes, the indication disappears. • When noise bars appear during playback, the camcorder enters the Auto Tracking mode and “AT” appears. • Manual Tracking may not work with tapes recorded on other VCRs or camcorders.
  • Page 15: Tape Dubbing

    The S-Video cable is optional. Be sure to use the following cable: YTU94146A S-Video cable. Consult the JVC Service Center described on the sheet included in the package for details on its availability. Make sure to connect the end with a core filter to the camcorder.
  • Page 16: Cassette Adapter

    Using The Cassette Adapter Use this to play back an S-VHS-C/VHS-C video cassette recorded with this camcorder on a S-VHS/ VHS VCR. 1) Slide the battery cover up to remove it, install one “AA (R6)” size battery, then reattach the cover.
  • Page 17 During Recording – – – – – – Refer to this diagram while reading the instructions. During shooting Keep the lens cap attached to the camcorder. Cassette holder 90° 90° 180° LCD monitor Microphone LCD Monitor/Viewfinder Indications – – – –...
  • Page 18: Brighten The Image

    MENU SETTINGS Set the Power Switch to “ down the Lock Button located on the switch. Press the MENU Wheel Screen appears. Rotate the MENU Wheel select the desired function. • To go from CAMERA MENU to SYSTEM MENU, rotate the MENU Wheel to select “...
  • Page 19 M.W.B. If the white balance is correct, all other colors will be accurately reproduced. AUTO : White balance is adjusted automatically. FINE : Outdoors on a sunny day. CLOUD : Outdoors on a cloudy day. HALOGEN : A video light or similar type of lighting is used.
  • Page 20: Recording Mode

    Technology). S-VHS REC appears during recording. OFF: Records in VHS on a VHS or S-VHS cassette. • JVC EHG (Extra High Grade) tapes are recommended for superior results. Use S-VHS tape for storing recordings for an extended period or for recording important scenes, as it enables higher-quality recording and playback.
  • Page 21: Tele Macro

    , tape remaining time, , tape length ( pg. 9, 17). DATE/TIME DISP. Makes the date/time appear in the camcorder or on a connected monitor (set DATE/TIME in SYSTEM MENU first pg. 7). • The selected display will be recorded. If you do not want to record the display, select OFF before shooting.
  • Page 22 • When a tape whose erase protection tab is in the position that allows recording is loaded in the camcorder, demonstration is not available. • If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration activated on the LCD monitor or viewfinder.
  • Page 23: Fade-In/Out

    ADVANCED FEATURES Fade/Wipe Effects Fade- or wipe-in works at recording start, and fade- or wipe-out works at recording end. 1) Set the Power Switch to “ down the Lock Button located on the switch. 2) Press FADE/WIPE repeatedly until the desired mode appears.
  • Page 24: Digital Effects

    Digital Effects 1) Set the Power Switch to “ down the Lock Button located on the switch. 2) Press DIGIFECT repeatedly until the desired mode appears. • To cancel the effect, press DIGIFECT repeatedly until “OFF” appears. SEPIA: Recorded scenes have a brownish tint like old photos.
  • Page 25: Troubleshooting

    Before consulting your JVC dealer, please check the following to see if you can correct the problem yourself. Vertical white lines appear when shooting a very bright object. • This sometimes occurs when the contrast between the back-ground and the object is great. It is not a defect of the camcorder.
  • Page 26 • When operating, keep a distance of about 30 cm between the video light and people or object. • Do not use near flammable or explosive materials. • It is recommended that you consult your nearest JVC dealer for replacing the video light. General Battery Precautions If the cassette adapter is not functioning even if it is being operated correctly, the batteries are exhausted.
  • Page 27 Changes and modifications not approved by JVC could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
  • Page 28: Specifications

    • Active Carrying Bag CB-V7U • A/V (Audio/Video) Cable • S-Video cable Some accessories are not available in some areas. Please consult your nearest JVC dealer for details on accessories and their availability. : 1 V (p-p ) , 75 Ω unbalanced, analog output (via Video output connector) : 300 mV (rms), 1 kΩ, analog output...
  • Page 29 Enganche. Conmutador BAT- TERY RELEASE Batería A la toma Adaptador de corriente alterna de CA CARGA DE LA BATERIA 1) Asegúrese de que la batería esté colocada en la cámara de video. Enganche el extremo a la cámara de video y presione la batería hacia el interior hasta que quede bloqueada en su lugar.
  • Page 30 ALMACENAMIENTO DE LAS PILAS: Antes de almacenar los paquetes de pilas por un largo período de tiempo, asegurarse de descargarlos completamente tomando las siguientes medidas para no reducir el rendimiento de la pilas. 1) Coloque la pila en la videocámara sin ningún cassette insertado.
  • Page 31 ESPAÑOL — GUIA PARA OPERACION RAPIDA Si la unidad comienza a funcionar mal, deje de usarla inmediatamente y consulte a su concesionario local de JVC. Colocación/Extracción de un cassette 1) Abra completamente el monitor LCD y manténgalo alineado verticalmente con la cámara (no lo incline de un lado).
  • Page 32 REPRODUCCIÓN 1) Cargue una cinta. 2) Ajuste el conmutador de alimentación “PLAY” mientras presiona el botón de bloqueo localizado en el conmutador. Para iniciar la reproducción, presione 4/6 Para interrumpir momentáneamente (reproducción de imágenes fijas), presione 4/6 & . Para interrumpir la reproducción, presione 5 .

This manual is also suitable for:

Gr-sxm161us

Table of Contents