Advertisement
8024B
VOLTS (V)
OFF*
OUT FOR DC*
(IN FOR AC)
IN FOR 20V
RANGE
OUT FOR v*
FUNCTION
*NOTE
The PEAK-HOLD switch and Function switches are push-push
type. Operate these switches by pushing to the RIGHT ® only!
Do not push or pull these switches to the left (out or off) positions.
®Connect the test leads as shown above.
®Depress the grey switch beside the range desired (20V is
shown selected).
®Set the AC/DC switch out for DC or in For AC (DC is shown
selected).
WARNING
TO AVOID ELECTRICAL SHOCK AND/OR INSTRUMENT DAMAGE,
DO NOT CONNECT THE 8024B TERMINALS TO SOURCES THAT
EXCEED
THE
FOLLOWING
LIMITS
WHEN
MEASURING
VOLTAGES:
COMMON:
500V
DC
OR AC
RMS
WITH
RESPECT
TO
EARTH
GROUND.
V-{2-S: 1000V
DC
OR 750V AC RMS
WITH
RESPECT
TO THE
COMMON
TERMINAL
(IN THE
200mV
RANGE,
SOURCES
GREATER
THAN 300V DC OR AC RMS SHOULD
NOT BE CON-
NECTED LONGER THAN 15 SECONDS).
®Connect the test leads to the circuit being measured.
@Read the measured value on the display. The minus sign will
appear if the V-Q-S terminal is negative with respect to the
COMMON terminal.
Figure 2-6. Volts Operation
Advertisement
