Computer Interface Using Watchgas Suite; Connecting And Configuring - WatchGas NEO User Manual

5.9.2 FACTORY RESET
If the App used to communicate cannot locate the NEO, resetting the factory parameters
may help. Press the Right key
6. COMPUTER INTERFACE USING WATCH-
GAS SUITE
The WatchGas Suite software can be used to 1) download logged data, 2) upload
configuration parameters to the instrument, 3) monitor data in real time and 4) upgrade
the instrument firmware. WatchGas Suite and instrument firmware can be downloaded
from our website at https://www.wacthgas.com.

6.1 CONNECTING AND CONFIGURING

1. Turn on the instrument and press Up from basic User Mode to go into PC comm.
2. Connect the USB cable to the PC and the Micro-USB end to the instrument.*
WARNING
Connect only in non-hazardous environment!
3. Start WatchGas Suite on the PC and click the "Search" button to find the instrument.
4. Find the instrument in the left bar Device Connected list. Click on the S/N to get the
configuration file from the instrument.
5. Edit the configuration parameters as desired and click "Write" to upload the configuration
to the instrument.
6. "Read" allows downloading the current configuration file from the instrument.
7. "Save" allows storing the current configuration file to the PC.
8. "Load" allows calling up a stored configuration file from the PC to WatchGas Suite.
9. To update the instrument firmware, select "Firmware Upgrade". The firmware must
first be downloaded to the PC from the WatchGas website www.watchgas.com.
*NOTE: Any locally-obtained USB A to Micro B USB cable will work for battery charging, but
will not work for communication with WatchGasSuite software. The WatchGas USB cable
P/N M-011-3003-W00 is required for a PC to recognize the instrument and communicate
with WatchGas Suite.
OK
Ent Esc
to initiate the reset count-down.
25