Monitor (Mnt) Setup - WatchGas NEO User Manual

CAUTION
Once the data are cleared, they cannot be recovered.
1. Press the Right key
2. Press the Left key
3. Press the Up key
Ent Esc
display shows 'Datalog Cleared!' and moves to the next sub-menu, Interval.
5.7.2 INTERVAL
Intervals are shown in seconds. The default value is 60 seconds
and the maximum is 3600 seconds (1 hour). There is enough
data capacity to run for 6 days at 1-second intervals, 12 months
at 60-second intervals, or 6 years at 10-minute intervals. Once
the datalog is full, it cycles and begins to replace the oldest data.
To change the Datalog Interval, press the Up or Mode key to increase or decrease each
digit's value, and the Right or Left key to move the cursor. Then move the cursor to '√' and
press Up to save and exit.

5.8 MONITOR (MNT) SETUP

Several settings can be accessed here, including date and time, pump parameters, display
parameters and selecting 3-point calibration.
5.8.1 DATE AND TIME
The date is expressed as Month/Day/Year, with two digits
for each. To change the date press the Up or Mode key to
increase or decrease each digit's value, and the Right or Left
key to move the cursor. Move the cursor to '√' after the
setting is complete, and press Up to save and exit.
OK
Ent Esc
to clear the datalog. The display asks, 'Clear Datalog?'
OK
Ent Esc
if you do not want to clear the datalog.
if you want to clear the datalog. When it has been cleared, the
OK
21