EL24i-16
Connection and commissioning
4
Before connecting the device, check that the specified mains voltage on the
type plate of the device is the same as that available to you. These are
230V/50Hz.
Due to the circuit design of the EL24i-16, no special sequence is required for
operation and connection. We recommend the following procedure. It pro-
vides you with the most efficient information.
1. Plug the device into a power outlet. A brief flash on and off of the LED
indicators confirms that the device has successfully completed its self-test
and is ready to be charged. The green LED lights up.
2. Connect the device to the battery with the correct polarity.
blue or No. 2
= battery minus
brown or No. 1
= battery plus
The sensing port M8 is for external monitoring and is assigned as follows:
© Nortec-Electronics 2019
Operation manual
Operation manual
Page9
Page10
Pin 1 = brown Pin 2 = white Pin 3 = blue Pin 4 = black
EL24i-16
© Nortec-Electronics 2019