Required Tools; Installation Requirements - Body Solid SCB-26 Assembly Instructions & Owner's Manual

CAUTION: To set up this unit, you will need assistance. Do not attempt assembly by yourself.
You must review and follow the instructions in this Owner's Manual. If you do not assemble and use the SCB26
according to these guidelines, you could void the Body-Solid warranty.

Required Tools

The basic tools that you must obtain before assembling
the SCB26 include but are not limited to:
m Standard Wrench Set
m Adjustable Wrench

Installation Requirements

Follow these installation requirements when assembling
the SCB26:
Set up the SCB26 on a solid, flat surface. A smooth, flat
surface under the machine helps keep it level. A
level machine has fewer malfunctions.
Provide ample space around the machine. Open
space around the machine allows for easier access.
Insert all bolts in the same direction. For aesthetic
purposes, insert all bolts in the same direction unless
specified (in text or illustrations) to do otherwise.
Leave room for adjustments. Tighten fasteners such as
bolts, nuts, and screws so the unit is stable, but leave
room for adjustments. Do not fully tighten fasteners
until instructed in the assembly steps to do so.
Fill out and mail the warranty card.
P r e p a r a t i o n s
CAUTION:
Be careful to assemble components in the sequence
presented in this guide.
NOTE:
4
Obtain assistance! Do not attempt to
assemble the SCB26 by yourself.
Review the Installation Requirements
before proceeding with the following
steps.
With so many assembled parts, proper
alignment and adjustment is critical. While
tightening the nuts and bolts, be sure to leave
room for adjustments.