ICON Health & Fitness PRO-FORM 590 LT User Manual page 13

15. Partially tighten two M8 x 25mm Bolts (4) with
two M8 Star Washers (9) into the Left Upright
(79) and the Left Handrail (21); do not fully
tighten the Bolts yet.
Next, partially tighten two M8 x 25mm Bolts (4)
with two M8 Star Washers (9) into the Right
Upright (80) and the Right Handrail (100). Then,
tighten all four Bolts.
See steps 5 and 8. Tighten the M10 x 96mm
Bolts (7).
Raise the Crosswalk Arms (82).
16. Raise the Frame (57) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Storage Latch (54) so that the large
barrel and the Latch Knob (55) are in the posi-
tions shown.
Attach the upper end of the Storage Latch (54)
to the Frame (57) with a 3/8" x 1 3/4" Bolt (6)
and a 3/8" Jam Nut (5).
Attach the lower end of the Storage Latch (54) to
the Base (99) with a 3/8" x 1 3/4" Bolt (6). Note:
It may be necessary to move the Frame (57)
back and forth to align the Storage Latch with
the Base.
Lower the Frame (57) (see HOW TO LOWER
THE TREADMILL FOR USE on page 21).
17. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see
pages 23 and 24).
15
21
9 9
4
79
82
16
57
5
55
Large
Barrel
99
13
4
100
9
4
6
54
6
4
9
80