Program The Travel - Chamberlain 98032 User Manual

Adjustment
3

Program the Travel

Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY
INJURED or KILLED by a closing garage door.
• Incorrect adjustment of garage door travel limits will interfere with proper operation of safety reversal system.
• After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact with
1-1/2" (3.8 cm) high object (or 2x4 laid flat) on floor.
Note: While programming the travel, the UP and DOWN buttons can be used to move the door as needed. During the
Automatic Force Setup, the door will automatically open and close.
1
Press and hold the UP Button until the door is in
the desired UP position.
4
Automatic Force Set Up
Once both the up and down positions have been manually set, the Safety Reversing Sensors will reconnect and become
operational. Then, the opener will enter a force-sensing operation by automatically moving the door open and close. The
garage door opener will sound an audible and visual alert before automatically opening and closing the door. The garage
door opener will beep three times, confirming that the Automatic Force Setup completed successfully. Adjustment is
complete.
If you hear one long beep after the door attempts to move, then the Automatic Force Set Up has not completed
successfully. Please start over at step 1 of Program the Travel.
16
2
Once the door is in the desired
UP position, press and release
the Adjust Button to start the
Auto Program Limit Sequence.
The garage door opener will
sound an audible and visual
alert before automatically
opening and closing the door.
The opener will automatically determine the DOWN
position of the door. The garage door opener will
sound an audible and visual alert before automatically
opening the door partially and closing the door again
to refine the DOWN position. Program the Travel is
now complete.
Note: If the garage door opener remote work light
flashes 5 times, then programming has timed out and
the door travel limits have not been set. Please restart
the program the travel process.
For the complete manual visit LiftMaster.com/Customer-Support