Advertisement

Quick Links

COEF srl.
Via Albinatico, 80-82
51019 Ponte Buggianese (PT)
ITALY
www.coef.it / www.coef.net
Code 02B012 - Sirio 1800 DV
Code 02B013 - Sirio 2500 DV
• OPERATING INSTRUCTIONS
Revision 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sirio 1800DV and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for COEF Sirio 1800DV

  • Page 1 COEF srl. Via Albinatico, 80-82 51019 Ponte Buggianese (PT) ITALY www.coef.it / www.coef.net Code 02B012 - Sirio 1800 DV • Code 02B013 - Sirio 2500 DV • • OPERATING INSTRUCTIONS Revision 1...
  • Page 2: Advices For A Correct Installation

    • Cod. 02B013 Sirio 2500DV for MHD 2500W discharge lamp or HMD 2500W discharge lamp The Sirio 1800DV/2500DV can work in automatic mode or in synchro mode, otherwise may be controlled by 8 bit DMX control- lers. The input protocol is the DMX 512. To drive the Sirio 1800DV/2500DV we suggest to use our controller MasterShow 512.
  • Page 3: General Warranty Conditions

    OR RE-SHIPMENT OF THE EQUIPMENT. Do not leave the packaging elements (polystyrene, nylon, metal parts, etc.) unattended. TECHNICAL NOTES Sirio 1800DV discharge lamp 1800W •LAMP: discharge lamp MHD 1800W, Burning position: Horizontal (+/- 15°) •COLORS: CYM color mixing continuously variable (256 steps) •DIMMER: 0-100% continuously variable (256 steps)
  • Page 4: Before Using

    Before connecting the equipment to the power system: make sure that the mains voltage and frequency corre- spond to rated values. • The Sirio 1800DV/2500DV can be equipped for a mains voltage 230VAC, 50 or 60Hz on request: 208Vac, 60Hz; 200Vac, 50Hz For a power supply of 100V-120V it is necessary to use one auto transformer with the following features: •...
  • Page 5 • the air cooling input and output are located on the base of the side-shell, The Sirio 1800DV/2500DV has a IP rate 44 without filters installed and an IP RATE 54 with filters installed. You must use the filters in critical working conditions and, normally, when the fixture works outdoor.
  • Page 6: Control Panel

    CONTROL PANEL fig.4 On the control panel of the Sirio 1800DV/2500DV (pict.4) you can find, besides the display, the leds and the but- tons to use to set the spot. • “DMX” led flashing: DMX input present off: no DMX input •...
  • Page 7 SUMMARY OF THE PROGRAMMING FUNCTIONS OF THE Sirio 1800DV/2500DV About twenty seconds after the switching on, the number of the software version will be shown on the display in “X_00” format. Afterwards the first of the nine available menus will appear:...
  • Page 8 (the flashing shows that the selected option is different from the one previously stored). To exit from the selected op- tion without making any change press the MENU button. Here below is shown the complete list of the functions of the Sirio 1800DV/2500DV. The complete list of the DMX values can be found in appendix “A”...
  • Page 9 CONNECTION THE DATA LINK (DMX 512) The connection of the DMX signal to the Sirio 1800DV/2500DV must be made by using the signal input XLR 5 pin connectors which are located on the control panel of the fixture. (pict.5) The pin nomenclature of the connectors for the connection to the DMX signal is listed in the table. (pict.5a) In order to avoid any problem in the signal transmission, it is warmly suggested to use a cable for high speed data transmission (sect.
  • Page 10 EXAMPLE OF CONNECTION AND SETTING OF 4 “SIRIO 1800DV/2500DV” IN SYNCHRO - MODE MASTER SLAVE SLAVE SLAVE WARNING: the cables are the same as the DMX standard cable EXAMPLE OF CONNECTION AND SETTING OF 4 “SIRIO 1800DV/2500DV” IN INDIPENDENT AUTO - MODE MASTER MASTER MASTER MASTER Pag. 10 http://www.coef.it...
  • Page 11: Troubleshooting Guide

    • Phone number and fax number • Fixture serial number • Message that are you displayed on your Sirio 1800DV/2500DV display • Description of the problem and the troubleshooting procedures that you have performed so far to diagnose and resolve the fault.
  • Page 12 DATA LINK (DMX 512) TROUBLESHOOTING Appendix “C” - Table A2 Pag. 12 http://www.coef.it info@coef.it...
  • Page 13: Main Board Connections

    Check the main fuse, if it is blown check VR1 (normally it has a resistance = ¥). If it is in short circuit you must change it. Check D1 (Bridge Rectifier), if it is ok check C65. If the fuse is still blown, change U11 http://www.coef.net - info@coef.it Pag. 13...
  • Page 14 THE COMPLETE LIST OF DMX VALUES APPENDIX -A- THE COMPLETE LIST OF THE AVAILABLE GAMES APPENDIX -B- Pag. 14 http://www.coef.it info@coef.it...

This manual is also suitable for:

Sirio 2500dv02b01202b013

Table of Contents