Table of Contents
Advertisement
○ It may not be possible to charge some USB devices,
depending on the type of device.
PRECAUTIONS REGARDING THE DUST-RESISTANCE AND WATER-
PROOFING FUNCTIONS
This product conforms to IP56 protection class ratings (dust-resistance and water-proofi ng) for electrical equipment as
stipulated by the international IEC regulations. (Only the main unit conforms to the IP56 protection class ratings when
equipped with a battery.)
[Descriptions of IP Codes]
IP56
Protection rating for water penetration
Must be no adverse eff ects on the equipment when sprayed with powerful jets of water from all directions (water-
proofed).
(100 L of water per minute sprayed for approximately three minutes from a distance of approximately three meters
with the use of a spray nozzle with a diameter of 12.5 mm.)
Protection rating for external assault by solid objects
Dust that may cause adverse eff ects on the equipment must not be able to enter (dust-resistance).
(The equipment to be left non-operable in a test chamber in which particles of talcum powder with a diameter of
less than 75 μm are fl oating in the air with the use of an agitation pump at a rate of 2 kg per cubic meter for eight
hours.)
The equipment has been designed to withstand the eff ects of dust and water, but there is no guarantee that it will not
malfunction. Do not use or leave the equipment in locations where it is subject to excessive amounts of dust, or in locations
where it is submerged in water or subject to rainwater.
NAMES OF PARTS (Fig. 1 – Fig. 15)
Hammer case
1
Anvil (A)
2
Friction ring (C)
3
LED Light
4
Trigger switch
5
Switch panel
6
Battery
7
Hook
8
Handle
9
Push button
0
Housing
!
Anvil (B)
@
Friction ring (B)
#
Latch
$
Charge indicator lamp
%
Hexagonal socket
^
O-ring
&
Pin
*
Hexagonal socket
(
Groove
)
Screw
q
Battery level indicator
w
switch
Battery level indicator
e
lamp
Display panel
r
Light section switch
t
Light indicator lamp
y
Tightening mode
u
selector switch
Tightening mode
i
indicator lamp
Rubber cover
o
USB port
p
USB cable
a
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
WR36DA / WR36DB
: Cordless Impact Wrench
To reduce the risk of injury, user must read
instruction manual.
Direct current
V
Rated voltage
n
No-load speed
0
/min
Oscillation per minute
Bpm
Impact rate
Ordinary bolt
H
High tension bolt
Hm
High mode
Mm
Medium mode
L2m
Low 2 mode
L1m
Low 1 mode
MT
Tightening torque (Maximum)
Square drive size
Weight
kg
9
Advertisement
Table of Contents
