Table of Contents
Advertisement
Using the templet guide
The templet guide allows for repetitive cut with templet
patterns by using a templet.
1.
Loosen the screws on the base plate, and then
remove the base plate from the trimmer base.
2.
Place the templet guide on the base, and then
attach the base plate by tightening the screws.
Fig.52
► 1. Base plate 2. Templet guide
3.
Place the tool on the templet and move the tool
so that the templet guide slides along the side of the
templet.
Fig.53
NOTE: The actual cut size on the workpiece is slightly
different from the templet. The difference is the dis-
tance (X) between the trimmer bit and the outside of
the templet guide. The distance (X) can be calculated
by using the following equation:
Distance (X) = (outside diameter of templet guide -
trimmer bit diameter) / 2
5
1
6
2
Fig.54
► 1. Trimmer bit 2. Templet guide 3. Distance (X)
4. Outside diameter of templet guide 5. Templet
6. Workpiece
Using the trimmer guide
Optional accessory
The trimmer guide allows for trimming the curved side
like veneers for furniture by moving the guide roller
along the side of the workpiece.
Fig.55
1.
Loosen the clamp screw, then install the trimmer guide
on the trimmer base, and then tighten the clamp screw.
Fig.56
► 1. Clamp screw
18 ENGLISH
1
3
4
1
2
Advertisement
Table of Contents
