Table of Contents
Advertisement
Open the lock lever of the offset base, then attach
5.
the offset base to the tool.
1
Fig.19
► 1. Lock lever
6.
Mount the belt to the pulley with a stick like a
slotted screwdriver by rotating the belt manually.
Fig.20
► 1. Pulley 2. Belt
7.
Close the lock lever.
Fig.21
► 1. Lock lever
8.
Fig.22
► 1. Base plate
9.
offset base, and then tighten the collet nut.
1
2
Fig.23
► 1. Trimmer bit 2. Collet nut 3. Collet cone
10. Insert the hex wrench into the hole of the offset
base, and then tighten the collet nut with the wrench.
1
Fig.24
► 1. Collet nut 2. Wrench 3. Hex wrench
12 ENGLISH
Attach the base plate by tightening the screws.
Insert the collet cone and the trimmer bit into the
1
2
3
1
1
2
3
Advertisement
Table of Contents
