Vents Solo RA1-35 R User Manual page 8

Solo RA1-35/50/60-9/7 R (V.2)
3. Install the assembled regenerator and the limit ring into the air
duct.
In Solo RA1-35 R and Solo RA1-35 R V.2 models, the limit ring is
connected to the regenerator.
In Solo RA1-50 R V.2 and Solo RA1-60 R V.2 models the limit ring is
inserted separately.
4. Use a screwdriver to unscrew the self-tapping screw from the
casing and remove the front part of the indoor unit.
5. Attach the mounting plate and mark holes for the dowels with a pencil or marker. Drill the holes and insert the dowels.
Then install the mounting plate on the wall and the rear part of the indoor unit in the duct.
Fasten the rear part of the indoor unit with the screws on the mounting plate.
6. Install the front part of the indoor unit to its original position
and fix it with a screw using a screwdriver.
7. Install the outer ventilation hood or the grille.
www.ventilation-system.com
8