Table of Contents
Advertisement
Installation manual
23
5.2 Mechanical installation
To ensure steadiness of the machine it is important to fasten the machine to the foundation.
Level the machine by using stainless or galvanized steel washers between the machine and the floor. The washers
must be of a size to cover the support surface. Fit the washers and self-locking nuts supplied with the machine and
tighten well.
To tighten the nuts it is recommended to use a ratchet wrench, especially in the right rear corner. Then final tighten
torque as recommended spec is M16 (5/8 inch) = 150 Nm WN6–35: M10 (3/8 inch) = 40 Nm.
To tighten the nuts it is recommended to use a ratchet wrench, especially in the right rear corner. Then final tighten
torque as recommended spec is M16 (5/8 inch) = 150 Nm
fig.5463A
After the machine has been in use for a while, check and re-tighten the nuts if necessary.
All nuts shall be checked and re-tighten every year.
Floor
In this type of machine, the drum is attached directly to the frame. As a result the deck under the machine must be
stable enough to absorb the dynamic forces generated during spin cycles.
The combination deck and foundation must be able to withstand the loads indicated in the technical data table.
Some marine installations have very thin decks. Special attention to be taken. Reinforcing deck plus increased size
of foundation may be necessary.
Advertisement
Table of Contents
