Table of Contents
Advertisement
en Troubleshooting
Fault
No water is visible in
the drum.
Residual water is
present in the com-
partment
.
Vibrations and move-
ment of the appliance
whilst spinning.
Drum rotates, water
does not flow in.
Heavy foam build-up
High spin speed not
reached.
The spin programme
does not start.
44
Cause and troubleshooting
Water is below the visible area.
Not a fault – no action required.
▶
Do not add any extra water to the appliance while it
▶
is operating.
Insert in compartment
→ "Cleaning the detergent drawer", Page 35
▶
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 16
▶
The appliance feet are not fixed.
Secure the appliance feet.
▶
→ "Aligning the appliance", Page 16
Transit bolts have not been removed.
→ "Removing the transit bolts", Page 14.
▶
Load detection is active.
Not a fault – no action required.
▶
Note: The load detection can take up to two minutes.
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into compartment II (not for outdoor clothing,
sportswear or items stuffed with down).
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
A low spin speed is selected.
The next time you run a wash cycle, set a higher
▶
spin speed.
Reduced Ironing is activated.
Select the programmes that are suitable for the
▶
type of fabric.
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Spin programme.
▶
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
is blocked.
Advertisement
Table of Contents
