Table of Contents
Advertisement
Fault
Fluff on the laundry.
Fabric softener re-
mains in the detergent
drawer.
The laundry is too
damp.
Loud noises during
the spin cycle.
Cause and troubleshooting
Fluff has accumulated in the drum.
Run the Cottons 90° programme without any laun-
▶
dry or detergent.
The use of fabric softener is not supported for the se-
lected programme.
Before washing, check whether the use of fabric
▶
softener is supported for the selected programme.
→ "Programmes", Page 26
Unsuitable programme for the type of fabric.
There has been a power cut.
Check whether the lighting in your room or other
▶
appliances are working.
The load is too large.
After the end of the programme, warm laundry feels
damper than it actually is.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
Drying target not adjusted.
Load too small.
Water tap is closed during the drying phase.
Make sure that the water tap also remains open
▶
during the drying phase.
The ambient temperature is greater than 30 °C.
Ensure that the ambient temperature is below 30
▶
°C.
Insufficient air circulation at the appliance's installation
location.
Ventilate the appliance's installation location.
▶
The water pressure is low.
No remedial action possible.
Laundry is not spun sufficiently.
Always select the highest possible spin speed for
▶
the washing programme in question.
Thick and multi-layered fabrics require a longer drying
time.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 26
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 16
▶
Troubleshooting en
47
Advertisement
Table of Contents
