Table of Contents
Advertisement
n
Heat Spreader Assembly
A heat spreader may be included in your standard package. The heat spreader and compo-
nents required for mounting are illustrated below.
4
w *
n
S c r e
f * 4
d - o f
S t a n
h a s
T o C
The heat spreader is designed to be mounted onto the module as illustrated below. Please
make sure the contacting sides of the heat spreader and the module are correct — the CPU
side of the module shall be facing the interface metal side with legs of the heat spreader. Ro-
tate the module horozontally so the interface metal would sit right on top of the CPU.
h a s
T o C
1
e r *
r e a d
e t a l
t S p
H e a
e M
r f a c
I n t e
1
Chapter 2 Hardware Installation
e r *
r e a d
T o C
1
e r *
r e a d
t S p
e t a l
H e a
e M
r f a c
I n t e
s i s
n
D o w
S i d e
e t a l
e M
r f a c
I n t e
s i s
L e g
U p
S i d e
C P U
L e g
Chapter 2
s i s
h a s
s i s
Please follow the steps to mount the module and heat spreader combo onto your chassis.
h a s
T o C
Step 1:
Locate the mounting holes or screws on your chassis reserved for mounting the stand-offs.
The chassis is typically customized, in which case additional screws that conform to the chassis
design may be required to secure the stand-offs onto the chassis. Use a wrench to fasten the
stand-offs onto the chassis.
L e g
s i s
h a s
T o C
Step 2:
Rotate the module and heat spreader combo so that the I/O is facing the desired side, and place
the combo onto the stand-offs. Please make sure the screw holes of the combo align to those of
the stand-offs. Place the screws that come with the standard package into the screw holes, and
use a screw driver to fasten the screws until the combo is securely fixed onto the chassis.
s i s
h a s
T o C
13
s i s
h a s
T o C
www.dfi.com
Advertisement
Table of Contents
