Yamaha MT-10 2023 Owner's Manual page 31

Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Stop/Run/Start switch "
To crank the engine with the starter, set
this switch to " ", and then push the
switch down towards " ". See page
7-2 for starting instructions prior to
starting the engine.
Set this switch to "
in case of an emergency, such as when
the vehicle overturns.
Hazard switch " "
Use this switch to turn on the hazard
lights (simultaneous flashing of all turn
signal lights). The hazard lights are
EAU66040
used in case of an emergency or to
"
warn other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
". When re-
The hazard lights can be turned on or
off only when the key is in the "ON" po-
sition. You can turn the main switch to
the "OFF" or "LOCK" position, and the
hazard lights will continue to flash. To
turn off the hazard lights, turn the main
EAU66030
switch to the "ON" position and operate
the hazard switch again.
NOTICE
EAU94790
/ / "
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
Instrument and control functions
Cruise control/YVSL switches
See page 4-6 for an explanation of the
" to stop the engine
cruise control system.
See page 4-8 for an explanation of the
YVSL.
EAU91670
"MODE" and select switches
Use the "MODE" switch, the MODE up
"
switch to change YRC modes or edit
the PWR, TCS, and SCS settings from
the main screen.
MODE up "
change the selected YRC setting up-
ward.
"MODE" - push this switch to scroll left
to right among the MODE, PWR, TCS,
and SCS.
MODE down "
change the selected YRC setting
downward.
ECA10062
TIP

5-3
" switch and the MODE down "
" - push this switch to
" - push this switch to
The traction control system can
only be turned off from the main
screen. Select TCS with the
"MODE" switch, then push and
hold the MODE up " " switch un-
EAU94151
1
2
3
EAU93623
4
5
"
6
7
8
9
10
11
12
13