Installation To A Movable Stand Behind A Truck - Kesla 2009S User Manual

4.3.1 Installation to a movable stand behind a truck

* Fastening sheaths (2) should be mounted to the truck for the installation of the bracket (3).
- follow the truck manufacturer's/distributor's instructions.
* The rear mounting bracket (3) should be lifted to the fastening sheaths (2).
* The rear mounting bracket can be fitted with a stand manoeuvring cylinder (5), in which case the
truck will be fitted with an appropriate mounting kit with locking. Alternatively, the manoeuvring cyl-
inder can be installed to the truck's side and the mounting kit to the stand.
* The crane (1) should be lifted to the stand (3) and 6 pcs of studs M30 (4) mounted to the stand's
outermost holes. The studs should be tightened step by step with a torque wrench to 1.200 Nm
(122 kpm).
•
*Ensure that the rear mounting bracket's cross bar cannot move in the direction of shafts.
* Connect the crane's return and pressure pipes to the truck's hydraulic system. The truck's quick
release couplings are to be replaced with new ones, if necessary.
* The crane can also be fixedly mounted behind the truck (see section 2).
•
The falling of the rear mounting bracket must be prevented with
a safety chain.
At this stage a commissioning inspection has to be carried out
31
COMMISSIONING