Table of Contents
Advertisement
en Troubleshooting
Fault
flashes.
"Hot" and the drum
rotates.
"H:95" lights up altern-
ately with End.
All other error codes.
The drying time is too
long.
Creasing.
42
Cause and troubleshooting
Door is not closed.
Close the door.
▶
Laundry is caught in the door.
Remove any trapped laundry.
▶
Cooling process active.
Not a fault.
1.
Do not change the programme during the cooling
2.
process.
Note: The cooling process takes up to 10 minutes.
You can continue to operate the appliance.
Drum cleaning is required.
→ "Cleaning the drum", Page 35
▶
The water pressure is low.
See
▶
→ "E:30 / -10 and/or
Malfunction
Switch the appliance off and then on again.
1.
If the message appears again, disconnect the appli-
2.
ance from the power supply for at least 30 seconds
by pulling out the plug or by switching off the relev-
ant circuit breaker in the fuse box.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales
3.
service. Please specify the exact error message
when calling.
→ "Customer Service", Page 51
The ambient temperature is greater than 30 °C.
Ensure that the ambient temperature is below 30
▶
°C.
Insufficient air circulation at the appliance's installation
location.
Ventilate the appliance's installation location.
▶
Fluff has accumulated in the drum.
Run the Βαμβακερά 90° programme without any
▶
laundry or detergent.
The load is too large.
The laundry lies in the drum for too long after drying.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
", Page 41
Advertisement
Table of Contents
