Troubleshooting - Bosch KDN43 Series Information For Use

Troubleshooting

14 Troubleshooting
You can rectify minor faults on your appliance yourself. Read the troubleshoot-
Troubleshooting
ing information before contacting after-sales service. This will avoid unneces-
sary costs.
WARNING
Risk of electric shock!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out by trained specialist
▶
staff.
Only use genuine spare parts when repairing the appliance.
▶
If the power cord of this appliance is damaged, it must be replaced by the
▶
manufacturer, the manufacturer's Customer Service or a similarly qualified
person in order to prevent any risk.
Fault
The appliance is not
cooling, the displays
and lighting are lit.
The LED lighting does
not work.
Side panels of the ap-
pliance are warm.
The temperature dif-
fers greatly from the
setting.
Condensation accu-
mulates on the sur-
face of the appliance
and on the shelves in-
side.
Cause and troubleshooting
Showroom mode is switched on.
Press and hold
1.
ible signal sounds.
After a short time, check whether your appliance is
2.
cooling.
Different causes are possible.
Call customer service.
▶
The customer service number can be found in the
enclosed customer service directory.
Not a fault. The side panels contain pipes which heat
up during the cooling process. Units touching the ap-
pliance will not be damaged by the heat.
No action required.
Different causes are possible.
Switch off the appliance. → Page 39
1.
Switch the appliance back on after five minutes.
2.
→ Page 39
If the temperature is too warm, check the temper-
‒
ature again after a couple of hours.
If the temperature is too cold, check the temper-
‒
ature again on the following day.
The water contained in warm and humid air con-
denses on the colder surfaces of the appliance.
Wipe away the water with a soft, dry cloth.
1.
Open the appliance as briefly as possible.
2.
Ensure that the appliance is always closed properly.
3.
Troubleshooting en
for 9–11 seconds until an aud-
45