Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 Do not stand close to the hazard area around rotating parts when Be sure to read these Safety Notes before you assemble your mo- del. Always keep to the procedures and settings recommended in an electric motor is connected to the flight battery.
Page 5
Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 Do not carry out modifications to the radio control system components Liability Exclusion apart from those described in the instructions. robbe Modellsport is unable to ensure that you observe the assembly and operating instructions, or the conditions and methods used for installing, Operating the model operating and maintaining the model components.
Page 6
Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 Dear customer, Congratulations on choosing a model aircraft from our ran- ge. Many thanks for placing your trust in us. The model can be completed and made ready to fly very quickly.
Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 Assembling the model Fit the tailplane into the slot in the fin from the left-hand side using only Fig. 4 Fig. 5 moderate pressure, until it is positioned flush with Slide the wing joiner spar into the right-hand wing panel the fuselage (Fig.
Page 8
Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 Using the charger to charge the flight battery Safety Notes regarding LiPo batteries: • Do not place the battery in water or any other liquid. The battery charger must be connected to a 12 V power • Do not heat or incinerate the battery; do not place it source with a minimum output power of 2 A using the con- in a microwave oven.
Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 Transmitter settings, Mode 1: Transmitter settings, Mode 2 (as supplied): Elevator trim Throttle trim Throttle trim Elevator trim Select switch Select switch Switch Switch Dual Rate Dual Rate Airbrakes Airbrakes Throttle Elevator Aileron Throttle...
Page 10
Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 "Primary" and "expanded" control function setting Converting the transmitter from "Mode 2" (throttle left) to "Mode 1" (throttle right) The transmitter offers the facility to adjust the sensitivity of the stick movements. We recommend "softer" reduced travels for beginners.
Page 11
Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 Transmitter settings Mode 1 Throttle trim: If the propeller starts to move without you touching the throttle stick, or does not respond to stick movements, cor- rect this with the throttle trim. Rudder trim: If the model's nose turns to right or left when launched, adjust the rudder trim...
Page 12
Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 Transmitter settings, Mode 2 Throttle trim: If the propeller starts to move without you touching the throttle stick, or does not respond to stick movements, cor- rect this with the throttle trim. Rudder trim: If the model's nose turns to right or left when launched, adjust the rudder trim...
Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 Flight preparation Richtige Vorgehensweise vor dem Start! Switch the transmitter on (Fig. 1).The battery status is displayed at the top of the screen. Move the throttle stick and trim to the lowest position. Open the canopy, place the fully charged LiPo flight battery in the recess, and use the Velcro tape to hold it in place.
Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 Controlling the model in Mode 1 Controlling the model in Mode 2 High RPM (launch): Motor off (landing): High RPM (launch): Motor off (landing): Right turn: Right turn: Left turn: Left turn: Descent: Climb: Descent:...
Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 Important Notes The first few flights Launching: Hold the model in your hand, set the motor to full power, and push the model forward smartly, directly into any wind. It is essential to adjust the trims so that the aeroplane flies in a stable attitude, climbing smoothly.
Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 Re-binding the transmitter This procedure is only necessary if individual components are replaced. Move the throttle stick and trim to the bottom position (motor stopped), then place the transmitter as close as possible to the receiver. Locate the horizontal trim switch below the right-hand stick unit on the transmit- ter, and push it to the left while you switch the transmitter on (Fig.
Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 Protective function of the BL speed controller with the Airbrake setting battery connected: In the default setting the airbrakes (ailerons) extend down- If the flight battery is connected to the SKY CLIMBER's BL ward.
Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 NE200101 NE200102 NE200103 NE200104 NE200105 NE200106 Replacement parts list - SKY CLIMBER RTF Order No. Description NE200101 Fuselage NE200102 Tail set NE200103 Wing NE200104 Propeller set NE200105 Control surface horns NE200107 NE200108 NE200109 NE200110...
Page 19
Operating instructions SKY CLIMBER RTF 2,4 GHz No. NE2001 robbe Modellsport GmbH & Co. KG hereby declares that this device conforms to the fundamental requirements and other relevant regulations of the appropriate CE Directive. Under www.robbe.com, you will find the original Conformity Declaration by clicking on the Logo button „Conform“...
Need help?
Do you have a question about the SKY CLIMBER RTF NE2001 and is the answer not in the manual?
Questions and answers