Rear Panel Controls And Functions - VocoPro CDG-600RF Owner's Manual

Rear Panel Controls and Functions

1. VOLTAGE SELECTOR SWITCH: This switch is used to select the voltage setting according to country. For use
in the U.S. the voltage selector should be set to 110v-120v and 220v-240v in Europe.
2. NTSC/PAL SELECTOR SWITCH: This switch is used to select the NTSC/PAL setting according to country. For
U.S. televisions systems it should be set to NTSC and for European television systems the selector should be
set to PAL.
3. 200W AC OUTLET: This outlet can be used to connect another component providing it does not exceed 200
watts maximum power consumption.
4. FUSE: IMPORTANT! If the fuse blows out it's a good indication that there may be a short in the system. DO
NOT REPLACE THE FUSE! Doing so could possibly cause additional damage to the unit. Take your CDG-
600RF to an authorized repair facility.
5. ECHO CONTROL FOR MIC-1 AND MIC-2: This controls the amount ECHO microphones 1 and 2 will receive.
Turn clockwise to increase echo and counterclockwise to decrease echo. (See "USING EFFECTS AND
CHANGING THE KEY", Adding Effects (Delay/Echo) To The Vocal Signal )
6. 3RD MICROPHONE/DJ/KJ INPUT JACK: This microphone input "bypasses" the echo feature and the bass
and treble tones are "preset". Therefore it is considered to produce a "dry" signal and there are no separate
bass or treble controls. It is best used for announcements by the host or hostess. The volume control for the
3rd microphone input is located just to the right of the input jack. (See #5, of the "REAR PANEL" diagram).
7. 3RD MICROPHONE INPUT VOLUME CONTROL: This controls the volume for the 3rd microphone input. Turn
clockwise to increase volume, counterclockwise to decrease.
8. TREBLE CONTROL FOR MIC-1 AND MIC-2: This controls the amount TREBLE tone microphones 1 and 2 will
receive. Turn clockwise to increase TREBLE tone and counterclockwise to decrease the treble tone. (See
"USING EFFECTS AND CHANGING THE KEY", Adding Bass or Treble To The Vocals)
9. BASS CONTROL FOR MIC-1 AND MIC-2: This controls the amount BASS tone microphones 1 and 2 will
receive. Turn clockwise to increase bass tone and counterclockwise to decrease the bass tone. (See "USING
EFFECTS AND CHANGING THE KEY", Adding Bass or Treble To The Vocals)
+
L
-
-
R
+
19
6 7 9
ECHO BYPASS
DJ MIC DJ MIC VOL BASS
AUX DVD LD
VIDEO
VIDEO
INPUT OUTPUT
L L
R R
AUDI0 INPUT TERMINAL AUDI0 OUTPUT
8 5
VIDEO ONLY
TREBLE ECHO
NTSC RF OUTPUT
MIC 1-2 CONT
www.vocopro.com
CALIFORNIA U.S.A
2 3 1 4
110-120V 220-240V
SWITCH TO:
NTSC FOR U.S. TV SYSTEM
PAL FOR EURO TV SYSTEM
NTSC PAL
VOLTAGE SELECT
VIDEO SYSTEM
AC 200W
CH3
OUTLET
UNSWITCHED