Riello RS 70/EV Installation, Use And Maintenance Instructions page 24

Once the combustion head adjustment is completed:
 push the burner on the sliding bars 3) at approximately 4" from
the pipe coupling 4) - burner in the position shown in Fig. 17;
 insert the electrode cable, then slide the burner as far as the
pipe coupling - burner in the position shown in Fig. 18;
 unscrew the 2 screws 2) from the extension 5) and reposition
them as previously Fig. 18.
 refit the screws 2) on the sliding bars 3);
 fix the burner to the pipe coupling with the screws 1).
When fitting the burner on the two sliding bars,
it is advisable to gently draw out the high volt-
age cable until it is slightly taut.
WARNING
20029395
Installation
2
5
6
5
5) Extension sliding bars
6) Lifting rings
22
4
4"
3
1
6
D10594
D10593
Fig. 17
5
6
Fig. 18