Table of Contents
Advertisement
INSTALLATION
UNPACKING
Having removed the outer carton, reinforcing angles
and polythene wrapping, you must take out the internal
packing which protects the appliance's 'works' during
transit.
Open the lid of your washing machine and take the
polystyrene block away. See Fig. 1.
Then using a spanner remove and pull the 2 threated
pins
A
; remove the 2 red plastic sleeves
B
using the
ring. Do not remove the black protective caps.
See Fig. 2.
Plug the holes left by pins
A
with plugs C {to be found
in the plastic bag with the instruction manual) taking
care to shut down the central part as shown on Fig. 2.
If you want to keep the alignment of
your appliance with the adjacent
cupboards, you have the possibility
to cut the crossbar holding the hoses
located in the back of your washing
machine (fig. 4)
INSTALLING
Your new Zanussi washing machine has been
designed to be permanently plumbed into your home's
water supply, and drainage system.
However, if this is not possible, it may be connected to
suitable existing taps, with the drain hose discharging
into a sink.
Lay the machine carefully on its back making sure that the
hoses and mains lead and plug are not squashed.
Unscrew and remove screws D. Lift away part E. Keep for
future use. See Fig. 3.
The appliance has one inlet valve, cold, with female 2/
4" BSP thread connector. If this connection size is not
compatible with the plumbing of the existing installation,
a variety of connectors are available from good
hardware stores and plumbers merchants to suit most
domestic plumbing. Any alterations to your existing
plumbing must be carried out by a competent person,
or qualified plumber.
The water inlets are normal for cold water ("smooth"
grey pipe) and red for hot water (grey pipe).
Fig. 5
6
Advertisement
Table of Contents
