Servicing - Electrolux TJ1053 Instruction Booklet

SERVICING
Before contacting your local Zanussi Service Centre, please make the following checks :
PROBLEM
CAUSE
SOLUTION
The Machine
• The On-Off button is not depressed
• Press the On-Off button
Does Not Start Up
• The lid is not closed properly
• Close the lid
• The appliance is not plugged in
• Plug the appliance in
• There is no electricity supply from
• Check the fuse
wall socket
• Consult a qualified electrician
(with pilot light on)
• The programme selector is not
• Press and turn the programme
correctly positioned
selector to the required
programme
* No water is entering the machine
• See solutions to the problem :
THE MACHINE DOES NOT FILL
The Machine Does
• The water tap is not on
• Turn the tap on
Not Fill
• The water supply has been cut off
• Wait until the water supply is
restored
• The inlet hose is bent
• Straighten the bend out
• The water pressure is too low
• If this occurs often, consult a
qualified plumber
* The water inlet filter is clogged
• Clean the filter see page 27.
The Machine Empties
• The end of the drain hose is too low
• Position the drain hose at the
As it Fills • correct height (Between 60 and 90 cm)
• The end of the drain hose is submerged
• The end of the drain hose
in water
must NOT be submerged
• Drain pipe without vent-hole
• Consult a qualified plumber
The Machine Does
• You have pressed the 'Rinse Hold' button • Press the button again to
Not Drain Or Spin
drain the water
• The drain filter is clogged
• Clean the filter, before doing
this see page 27.
• The drain hose is bent
• Straighten the hose out
• The drainage system pipes are blocked
• Consult a qualified plumber
• The drain hose extension is incorrect
• Consult a qualified plumber
The Machine Leaks
• Too much washing powder
• Reduce the quantity of
Or Overflows
washing powder
• Unsuitable washing powder
* Only use washing powder
suitable for automatic
machines
• The inlet hose ring is loose
• Tighten the ring (see page 7)
• The detergent dispenser recess is
clogged
• Clean the recess (see page 26)
• The end of the drain hose is not
• Position the drain hose
correctly positioned
correctly
19