AC Infinity THERMOFORGE Series User Manual page 7

Environmental vpd heater
Table of Contents

Advertisement

PRODUCT WARNING
10.
Do not handle any part of this product or plug with wet hands. Suitable for dry locations ONLY.
This product is not intended for use in bathrooms, laundry areas, or similar indoor locations.
Never place this product where it may fall into a bathtub or other wet environments. Do not use
or store this product where it may get wet, including but not limited to, surrounding areas of
baths, showers, or swimming pools.
11.
Do not cover power cords with rugs or other fabric materials. Do not route cords under
furniture or appliances. The cord should not hang over edges or be placed where it can be
bent or closed in doors. Place this product near an easily accessible outlet so the product can
be unplugged quickly during an emergency.
12.
Plug this product directly into a wall outlet. Never use with an extension cord or relocatable
power tap (outlet/power strip). Do not use this product on a surge-protected unit or Ground
Fault Circuit Interrupted (GFCI) outlet. Do not yank, strain, stretch, or wet the power cord.
13.
Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust openings as
it may cause electric shock, fire, or damage to this product. Do not block or tamper with this
product in any manner while it is in operation.
14.
To prevent a possible fire, do not block air intake or exhaust openings in any manner.
Do not use this product on soft surfaces, such as beds, where openings may become
blocked. Do not put any object into the inlet grill or the exhaust opening as this may cause
an electric shock or fire, or damage this product.
15.
To prevent overload and blown fuses, be sure that no other appliance is plugged into the same
outlet or into another outlet wired into the same circuit.
16.
Never ignore signs of an electrical problem, such as: warn outlet cover plates, sparks when
plugging or operating, lights flickering/dimming during operation. Immediately turn off and
unplug this product if any such problems are noticed. Contact a qualified electrician to
investigate possible causes before operating this product again.
17.
It is normal for the plug and cord to feel warm to the touch. A plug or cord that becomes hot
to the touch or becomes distorted in shape may be a result of a worn electrical outlet. Worn
outlets or receptacles should be replaced prior to further use of this product. Plugging this
product into a worn outlet may result in overheating of the power cord or fires.
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thermoforge t3Thermoforge t7Ac-sft3Ac-sft7

Table of Contents