Table of Contents
Advertisement
PROGRAMMING
FAN FUNCTION
CYCLE MODE (ON AND OFF)
Sets an on duration and an off duration for your
heater to cycle through continuously. Press the
up or down button to first set a duration for it to
activate. Then press the mode button again and
set a duration for your heater to deactivate.
When your heater are activated, it will run at
the level set in ON Mode. When your heater is
deactivated, they will run at the level set in
OFF Mode.
The countdown will begin if no buttons are
pressed for 5 seconds. The time left on the
countdown before the next ON or OFF phase is
displayed below the current level. Leaving the
CYCLE Mode while the countdown is running will
pause it until you return to this mode.
28
1hr.
30min.
If there is a level set in OFF Mode other
than zero, your heater will run at that
level when triggered to turn off.
30min.
1hr.
Advertisement
Table of Contents
