Advertisement
3. Installing CPM100 CANopen Board
*
PISO-CPM100U is PCI slot
PEX-CPM100 is PCIe X1 slot
4. Wiring and testing
Step1. Connect the CAN port of the CANopen board to the customer's
CAN device and power on.
Step2. Open CPMUtility.exe located in C:\ICPDAS\PISO-CPM100U.
Step3. Press the Module button, click on the appropriate CANopen card
and baud rate and add a new one.
Step4. Click AddNode to search for slaves, then select the slaves and
add them. After adding the slaves, you can use CPMUtility to
control or read the data from them.
Step3. Figure
Step1. Shut down and power off your
PC, then remove its' case.
Step2. Select a suitable slot and insert
the CAN card into the slot.
Step3. Replace the PC case and
power on the computer.
Step4. After the boot is complete,
please follow the prompts to
complete the driver installation.
Step4. Figure
P4
Advertisement
