Advertisement
L e s e t a d
spseptyemminan aan? idl banshee 52¢aRanat eneSacli nocetanedstntiron deh owt
heres? ae Moae its Sai avevbntenpabestoath hepecnmertin ste state bataeS etomidate
be
Using the Best Stations Memory
{(BSM)
The radio stations having a strang signal
can be tuned automatically and stored in
memory
under buttons tto 6 [70]. Press
button [6] for at least 2 seconds. (The ".---"
will blink.) After "----" stops blinking, the
stations will be stored in memary under
buttons 1 to & of [10].
- BSM can be canceled mid-operation by
pressing button [6].
« The stations will be stored under buttons
1 to 6 in the order of their signal strength.
The strongest station will be stored under
button 1, followed by stations with lower
signal strengths.
« if there are fewer than 6 stations whose
signal is strong, there will be spare
memory.
> Itwill take atmast 30 seconds for BSM to
be completed.
Preset Scan Tuning
This recalis in sequence all the stations
stored In memory under the buttons [10]
for 8 seconds each. Press button [6}. (The
{21} number will blink.} To cancel, press the
button again. After the desired station is
tuned, cancel the preset scan tuning. The
station will then cortinue to be received.
» Stations stored in memory under the
buttons [10] but whose signal is weak will
not be recafied.
Local Seek Tuning
When the local rode is set, the seek
tuning's sensitivity levet will become high
and only stations with a strong signal will
be seek tuned. The local mode's seek
sensitivity can be adjusted.
Setting the Local Made
Press button [5}). (The "LOC.S" [24] will
light.) To cancel the local made, press the
button again.
Adjusting the Local Seek Sensitivity
There are 4 local seek sensitivity steps for
FM and 2 steps for AM.
* LOC-4 is the highest seek tuning
sensitivity level. Only the stations with a
strong signal are tuned. LOC-3, LOC-2,
and LOC-1 in descending order enables
the tuning of stations with a respectively
weaker signal.
1.Set to locat seek sensitivity adjustment
mode. Press button [5] for at least 2
seconds. (The current sensitivity level
"LOC?" will be displayed.)
+ The local seek sensitivity adjustment
mode will be canceled after about 5
seconds.
2.Adjust the sensitivity level by pressing
(~€) or (} of bufton [2].
FM Monaural Reception
if a stereo broadcast has a fot of noise,
switching to the monaural reception mode
will reduce the noise. Press button [7].
("MONO" {23} will appear on the dispiay.}
To cancel, press the button again.
13
Advertisement
