Advertisement
DIN Rear-mount
installation using the screw hales on the
sides of the unit
1.Remove the frame. (Fig. 9}
13. Frame
14. insert the release pin into the hole in the
botiom of the frame and pull aut to remove
the frame.
(When reattaching the frame, point the side
with a groove downwards and attach i.}
2. Fastening the unit to the factory radio
mounting bracket. (Fig. 10) (Fig. 14}
15. Select a position where the screw holes of ihe
bracket and the screw holes of the main unit
become aligned (are fitted), and tighten the
screws at 2 places on each side. Use either
bind screws {5 « 8 mm} or flush surface screws
{5x8 mm}, depending on the shape of the
screw holes in the bracket.
16.Screw (5 » 8 mr}
17. Factory radio mounting bracket
18, Dashboard or Console
socom ocemannantnataapnnanste rine hemlet tnbanransoauiataadaun nated
natant
isin
Aa ae
RR
Eel ava
"3
installing the Remote Controller
Unit (Fig. 12)
+ DEH-303, DEH-203 do not came with a
remote control.
Affix a strip of Velcro tape to the back of
the rernote control unit. Remove the oil
paper on the back and affix into place.
* Thoroughly wipe off the surface before
affixing the Velcro tape.
18, Rough surface
20. Attach Velcra tape to the back of the remote
controd wank.
21. Soft surface
22. Remove the olipaper from the back and
attach,
Fig. 1
Advertisement
