Advertisement
rei iaKiaee nctatit rep bbaationig. tobe, ees stie:
DIN Front/Rear-mount
This unit can be properly installed either
from "Front® (conventional DIN Front-
mount} or "Rear" (DIN Rear-mount
installation, utilizing threaded screw holes at
the sides of unit chassis). For details, refer to
the following illustrated installation
methods.
DIN Front-mount
installation with the rubber bush (Fig. 5)
Installation without the rubber bush
(Fig. 6}
1. Dashboard
2. Holder
After inserting the hotder into the dashboard,
select the appropriate tabs accarding to the
thickness of the dashboard material and bend
them inwards to secure the holder in place.
Rubber bush
Screw
Nut {S mm)
Orilta 5.5 -- 66mm
diameter hole.
Screw (6 * 16 men}
Strap
Be sure to use the strap to secure the back of
the unit in place, The strap can be bend by
sand To the desired angle,
OI
& ow
he ER Ai bes CRED Shoe)
aa, tl W H
eS)
pews
Hee
Be.
oe
eS
Removing the unit (Fig. 7} (Fig. 8}
9. Frame
1OJnsert the release pin into the hale in the
boattam of the frarne and pull out to remove
the frame.
(Wher reattaching the frame, point the side
with a groove downwards and attach it.}
ji insert the supptied extraction keys into the
unit, as shown in the figure, untif they click
into place. Keeping the keys pressed against
the sides of the unit, pull the unit out.
12. Tab
Advertisement
