CONFIGURATION > Setting the dynamic range compression level
Setting the dynamic range compression level
Compressing the dynamic range of audio signals (the volume difference between the loudest and quietest
sounds) makes it easier to listen at a low volume. This setting is applied only when Dolby Digital audio
signals are being played.
Default setting: No compression
1
Turn off the sound bar.
2
Press the following remote control buttons according to the compression level you
want to set:
Compression level
Auto
Compression
No compression
The dynamic range compression level setting is changed.
The indicators on the front of the sound bar show the setting status as follows, and the sound
bar is turned on.
Compression level
Auto
Compression
No compression
Function
Apply an amount of dynamic range
compression well suited for a typical room.
Apply the maximum amount of dynamic
range compression.
Dynamic range compression is not applied.
Indicators not glowing
Glows
Glow
70
Buttons to press
(On the remote control, press the
buttons in order within three
seconds)
[STEREO] → [VOLUME +] → [z
(Power)]
[STEREO] → [VOLUME -] → [z (Power)]
[STEREO] → [| (Mute)] → [z (Power)]
Sound bar's indicators