Loading The Appliance Door - Thermador T18 Series Installation Instructions Manual

3. Nuts on the doubie threaded bolt:
for securing the furniture front to prevent lateral
movement.
4. Lower brackets:
for securing the furniture front to prevent lateral
movement.
Important information for furniture doors with cutout
(appliances with ice and water dispenser, wine storage
cabinets):
The cut edges of the door cutout must be protected before
humidity penetrates. To do this, use the means suitable
for the material and the snape of the furniture door (e.g. edge
veneer, edge sealant).
ere
Panel unification kit
In the case of 30" and 36" wide appliances 2 adjacent
furniture doors can be attached instead of one large door.
These furniture doors must be connected to a metal strip
on the rear.
This metal strip can be purchased from customer service
as an optional accessory, see the section on "Optional
accessories" on page 17.
When attaching ihe metal strip to the furniture doors,
observe the maximum possibie length of the screws and the
position of the drill holes. Always screw into the best load-
bearing material of the furniture door.
— Never screw into fillers, decorative strips or similar.
— lf only one furniture door is to be attached to the
door of a 30" or 36" wide appliance, attach the
supplied sandwich plate to the adjusting rail and
lock into position.
20. Loading the appliance door
When attaching the furniture doors, it is recommended to
load the door storage compartments in the appliance with
weights in order to ensure that the gap width is as precise
as possible.
Recommendations:
18" Appliance... 2... eee 22 los/10 kg
24" Appliance: 2... ee 33 llos/15 kg
SO" Appliance:. 0. ee 44 Ips/20 kg
31