Using An Sd Memory Card; Setting Date And Time; Attaching The Hand Strap - Vivitar Vivicam 3315 User Manual

digital camera
user's manual

Using an SD Memory Card

The V3315 camera is equipped with 8 MB of internal (built-in) memory.
In addition to saving your images in internal memory, you
may also store your images on a removable memory
card known as an SD (Secure Digital) card.
An SD memory card is not included with
the camera but be purchased at a computer,
photo, or electronics store.
To insert an SD memory card:
1. Make sure to turn the camera off
2. Open the Battery/SD memory card cover on the side of the camera (page 8)
3. Insert an SD card into the memory card slot:
* Insert the card as indicated by the arrow on the memory card
* The face of the SD card will be towards the camera lens
* Press the card until you hear a distinctive click
* Make sure the SD card has fully seated allowing the cover to be closed
3. Close the Battery/SD card cover
Note: To remove an SD card press on the edge of the card momentarily, and release
Setting the Date and Time
1. Power on the camera in any mode. Press the MENU button. (Page 1/Rear View, item 2)
2. "Setup" will be highlighted. Press OK. The SETUP MENU appears.
3. Press the Down Arrow button (Page 7/Rear View, item 4) to highlight DATE/TIME. Press OK.
4. Use the arrow buttons

Attaching the Hand Strap

1. Insert the thin end of the strap into the strap holder cutout,
under the metal post
2. Pass the other end of the strap through the loop of
the thin cord and pull the strap tight
10
(Optional accessory)
to make changes. Press OK to move to the next field.